WPI PZMIII Instruction Manual download pdf (Page 8)

4 World Precision Instruments

Fig. 5— Each PicoPump is supplied with a 5430-ALL PicoNozzle (Version 2) kit.

Legacy PicoNozzle Kits

NOTE: The legacy Version 1 PicoNozzle Kits are still available and sold separately and

also work well with the PicoPumps.

Fig. 6—PicoNozzle Version 1 Kits (#5430-10, 5430-12, 5430-15, 5430-20).

Version 1 PicoNozzle kits each contains:

(1) MPH6S microelectrode holder

(1) Handle for the MPH6S (4” hollow tube with male Luer ﬁ tting at both ends-handle

diameter is 6.25 x 100mm.)

(1) 5’ tubing (0.060” ID, 0.120” OD, male locking Luer ﬁ tting on one end and a female

locking Luer ﬁ tting at the other end, rated for 200 PSI and 86 durometer shore A)

The microelectrode holder is equipped with a female luer to attach to one end of the 4˝

male/male luer lock adapter. The 5´ tubing also has a female luer at one end to attach to

the opposite end of the 4˝ luer lock adapter. The male luer ﬁ tting of the 5´ tubing must be

cut off in order to attach it to the barbed pressure port of the PicoPump.

When using a MPH6S handle, a ﬁ rmer hold on the glass can be achieved by using two

gaskets in the micropipette holder. For a list of replacement parts (micropipette holders

and gaskets), see “Accessories” on page 18.

NOTE: Capillary holders can be obtained from WPI which contain Ag/AgCl half-cells.

These holders (MPH6S, MPH6R) can be easily mounted on ampliﬁ er headstage probes

so that potential and/or current, as well as pressure, can be measured or dispensed

through the capillary tip.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

WPI PZMIII Instruction Manual Page 8