WPI PZMIV User Manual download pdf (Page 10)

6 World Precision Instruments

OPERATING INSTRUCTIONS

Refer to Fig. 2 on page 3 and Fig. 3 on page 5 along with the following

instructions on normal operation.

1. Set up the microscope on the track stand. Mount the microscope head into the

focus mount. Use focusing knob to bring microscope to focus.

2. Looking through the eyepieces with both eyes, adjust the interpupillary distance

by sliding the two eyepiece tubes with both hands until a single image is

observed.

3. Place a sample under the microscope, turn magniﬁcation knob to its greatest

setting (5.0). Focus the image by turning the focusing knob. Once the image

is in clear focus at its highest magniﬁcation you may zoom out to lower

magniﬁcation by adjusting magniﬁcation knob while remaining in focus.

4. If image goes out of focus when zooming out, zoom to the lowest setting and

focus each eyepiece individually by adjusting the diopter adjustment ring.

5. For video or photo applications on the PZMTIV:

• Slide the light path selector bar to the “PHOTO IN” position in order to direct

the light to the video/photo port.

• Remove the protective cap on top of the video/photo port.

• Slip and secure the body of C-mount CCD camera coupler over the video/

photo port, with its focus ring facing back.

• Attach the C-mount video or digital camera (when using cameras with an

integrated lens ﬁlter thread of 28, 37 or 43 mm, the Digital Camera Adapter

Kit #501384 is required).

• Refer to the camera’s manual for connecting the camera to monitor.

• Focus the image on the screen by adjusting the ﬁne focus ring located at

the back of the C-mount CCD camera coupler.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

WPI PZMIV User Manual Page 10